Drive-On Ramps for ASWG004 Low Profile Turn Plates
Drive-On Ramps for ASWG004 Low Profile Turn Plates
Get all four wheels dead level.
Four drive-on ramps roll every wheel up to the same height. The front wheels settle on your ASWG004 turn plates, the rear wheels on two leveling platforms, so the whole car sits level at ride height. Rolling up seats each wheel firmly, so nothing shifts while you measure. Panels lock together by hand. No tools, no fasteners.
Level all four
Front wheels on the turn plates, rear wheels on two leveling platforms. Every corner at the same height, suspension at ride height.
4 ramps + 2 platforms
Four drive-on ramps plus two rear leveling platforms. Slide-lock panels, no tools, no fasteners.
Rolls on, stays put
Driving up seats each wheel firmly, so the setup does not shift while you pull readings.
Pairs with ASWG004
Sized to seat ASWG004 turn plates level with the ramp top, using the included TSB bridges.
Hard-floor use
Flat concrete or paved floor only. A level floor is what makes the reading hold.
Set up where you already work.
Place a ramp at each wheel, drive up, and stage your turn plates. The front wheels settle on the plates, the rear on the leveling platforms. The full alignment setup fits a standard home garage bay.
Staged in the bay.
A ramp under each wheel before drive-on. The vehicle rolls up until every wheel sits flat at the same height and stays put.
Bridged to the turn plate.
Transition bridges seat the ASWG004 turn plates level with the ramp top, so the front wheel rolls onto the plate without a step and stays seated.
Complete the entry system.
These ramps pair with the AutoSolo ASWG004 Low Profile Turn Plates. The front wheels need the plates as their level surface. Without them, the ramps have no alignment function. Buy both together.