

Locator Pin Tip Covers

01 · Fit the covers
Fit the covers.
Each cover pushes onto the tip of an AutoSolo locator pin by hand, so the rim edge of the wheel meets silicone, not bare metal. One cover fits both the 88 mm standard pin and the 137 mm extended pin.

Wedge to hook
Hold the cover so its wedge tip lines up with the hook on the pin.

Push until it stops
Push the cover on by hand to full depth. There is no gap at the base of the cover.
Check all four pins. A cover that sits part way on the pin will not hold.
02 · Mount the clamp
Seat. Push. Tighten.
When you attach the clamp to the rim, covered pins add three points.

Hook over the rim edge
Open the clamp wider than the rim. Place every pin so the tip of the cover hooks over the rim’s outer edge, all the way in.

Push toward the wheel
Hold the clamp against the wheel with one hand and tighten with the other. A tire sidewall can hold a pin off the rim at first. The push seats it.

Tighten, then tug
Tighten until the clamp is sturdy. The silicone pads the contact. Tug the clamp before you hang a gauge or a target on it. It does not move.
!Note
- A covered pin tip is thicker. A pin that sits part way onto the rim pushes the clamp off when you tighten.
If the clamp slides off the rim
TireRimA pin was only part way onto the rim. Only the tip of the cover touched the rim edge, so the cover slid off as the clamp tightened. This is not a defect.
TireRimLoosen the clamp, seat every pin fully, push the clamp against the wheel, and tighten again.
At a glance
| In the box | 4 covers, enough for 1 clamp |
| Fits | AutoSolo 88 mm and 137 mm locator pins |
| Material | Platinum cure silicone, 60 Shore A |
| To remove | Pull the cover off by hand |

