Language
ViewDownload PDFOther manuals

Brake Pedal Depressor

ASBPH1•Alignment Support Tool
Tutorial available on autosolotools.com
User Guide
AutoSolo · ASBPH101

01 · Assembly

Assembly instructions.

The ASBPH1 Brake Pedal Depressor is a durable, safety-critical device that holds constant pressure on the brake pedal by bracing against either the steering wheel or the driver’s seat. Use it in a garage or workshop, or during long-term vehicle storage. It helps prevent unintended vehicle movement, for a safer working environment.

!Important safety note

  • Do not disassemble this device. Internal components are factory-calibrated, and tampering may compromise safety and function.
01
01

Insert the subassembly into the actuator rod

Slide the holder subassembly down the actuator rod to the actuator housing.
02

Secure the subassembly

Insert and tighten both front and rear screws using the included hex key. This locks the subassembly to the actuator assembly.
03

Attach to the base rod

Screw the assembled rod into the base rod by turning clockwise until tight and secure.
02
03
04
Assembly instructions01
Operation · Usage02

02 · Operation

Operation instructions.

Squeeze lever to raise device

To raise the holder mechanism

Squeeze the main lever handle to raise the rod and holder mechanism to the height you need.

Release lever, push down

To lower the holder mechanism

Press the top release lever to release the lock, then push the device down to lower the mechanism.

Usage · Option A · Push against the steering wheel

01

Move the driver’s seat back to allow clearance.
02

Place the bottom of the device (pointed end) firmly on the brake pedal.
03

Center the steering wheel in a neutral (straight-ahead) position. Use the ASSTL1 Steering Wheel Level Tool to confirm it is level.
04

Position the holder mechanism directly beneath the steering wheel.
05

Squeeze the lever handle to raise the holder mechanism until the brake pedal is pressed with appropriate tension.
Operation and usage instructions02

Usage · Option B · Push against the driver’s seat

01

Place the bottom of the device (pointed end) firmly on the brake pedal.
02

Align the top mechanism against the front of the driver’s seat instead of the steering wheel.
03

Actuate the main lever until the brake pedal is fully depressed and tension is held.

To view this manual in other languages, scan the QR code.

Visit our websiteautosolotools.com
Multi-lingual Manualsautosolotools.com/manuals
For technical questions email or call us atsupport@autosolotools.com
415.849.0275
ASBPH1User Guide · v3.0 · 2026-11
©AutoSolo® 2026
All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced without the express written consent of AutoSolo.